Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - WilleCes

Pages: [1]
1
General Discussion / elbow issue
« on: August 26, 2019, 09:02:31 PM »
when its printing down low like that time you layers. 25-30 sec per layer should be fine for cooling. make sure your fan is on and also turn the bed down a little. try 60.

2
Questions & Answers About Our Products / fda registered products
« on: August 25, 2019, 07:51:46 PM »
I see where they template allows for multiple pre-options, like size & color, but I could not find anyone who asked about customized products. For example, we sell baseball gloves, and have the ability to embroider up to 20 characters on the gloves with different fonts, thread color and locations... Is this something the template will allow for?

If this type of customized option is not available currently is it something that we could get done with a custom order?

Thanks
Andy

Pages: [1]